![]() ![]() The battery lamp does not fully light but turns on with a dim light, and a dimmer battery lamp indicates insufficient charge. The problem can be corrected by removing the charging dynamo and repairing the necessary parts.ģ-If battery light is dim or off-and-on: In some cases, a so-called charge lamp flare may occur. If there is less voltage from this range and this voltage is rising when you press the glaze, there is a possibility of charging dynamo failure. The measurement made at the idle should be within the range of 13.7 – 15. You can do this with a tool attached to the battery pole heads. Solution: The voltage of the alternator (charger) should be measured while the car is idling. Usually the first reason that the car charger is not at a sufficient level. If the battery light is on while the vehicle is running but when you step on it, the lights of battery can go off. Solution: If there is a problem with the battery, you should check every part of electric current or you should chceck whether are there any leakage of electricity in your car or not.Ģ – When you step on it, the battery lights off: It is usually the first of the most common situations. If the battery charge lights are blinking…ġ – If there is a leakage of electricity: If there is a bypass in your car, if there is a leak, the battery charge light may blink depending on the situation of the leakage. One of the most common problems in vehicles is the problem of the battery discharge lamp blinking. The water pump (circulation pump) will also not work in the event of a V-belt breaking, in which case the engine will not cool down and overheats, causing severe damage to the motor.īattery Charge Lights Are Blinking (SOLVED) The alternator belt may break if it is over tensioned.ĪTTENTION: If the V-belt is broken, the engine must be stopped immediately and switched off if the charging lamp is on. The belt tension can be controlled manually by pressing it from the middle of the longest part of the belt in the gap, when the finger is pressed. Alternator belt (also called V-belt) is torn or belt tension has decreased or deformed.In this case, the fault can only be eliminated by changing the regulator. The regulator of the alternator can be get damaged.In this case, the problem is solved by simply disassembling the plug and replacing it with the new one, there is no need to replace the whole alternator. Alternator charcoals (brushes) may be exhausted or broken.The Reasons for Why Battery Charge Lights are Showing up If the service can not be called or if the service can be carried out for a short period of time, the electric receivers in the vehicle must be switched off as much as possible in order to save the situation so that the electricity consumption will be reduced, For this reason, in the daytime, the headlamps, parks must be closed, all of non-essential electrical equipments such as air conditioner, heater, music system, interior lighting can be closed and go to the nearest auto service. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |